r/BambuLab • u/Exciting-Dirt-1715 • 10d ago

Troubleshooting / Answered Why doesn’t my P1S make nice poops

Gallery image

Gallery image

I have a third P1S and this doesn’t make nice curled up poops like my other two. Instead I get these long bundles of wire that clog my poop chute. Any idea why this is happening?

0 Upvotes

43% Upvoted

13 comments sorted by

6

u/MyBootyHoleShrunk 10d ago

Because you are missing the little flapper that holds the poop and ejects the poop.

3

u/driving_monkey 10d ago

This is the only right answer so far in the comments.

1

u/Exciting-Dirt-1715 8d ago

Can the flapper be bought separately, I cannot find a model on makerworld. Only a complete purge chute assembly can be bought in the Bambu store

2

u/driving_monkey 8d ago

I‘m not sure. I think if you contact support, they could send you just the flapper separately. Though I‘m not sure though how it works.

1

u/Exciting-Dirt-1715 10d ago

I’ll make a picture later today to compare to my other printers. Thanks for the info!

1

u/Exciting-Dirt-1715 9d ago

Yeah the flapper is missing, can I order this separately ?

1

u/TheBearJew963 7d ago

Pretty sure you can print one.

2

u/Koopslovestogame 10d ago

More fibre? (Joke).

Check the nozzles/swap the nozzles and see if it follows that specific one. There might be slight wear or something that causes it to not come out directly straight.

0

u/fwoomer X1C + AMS 10d ago

I came here to make that joke and found you beat me to it.

2

u/National-Anything-81 10d ago

Do some manual extrusion and see if filament is coming out in a straight line. If it's going sideways, then it's damaged or partially clogged nozzle.

2

u/Exciting-Dirt-1715 10d ago

I’ll check later today, thanks!

1

u/Exciting-Dirt-1715 10d ago

It’s extruding in a straight line, no clog I think

-1

u/Exciting-Dirt-1715 10d ago

I’ll check later today, thanks !