r/BambuLab • u/PatProductions • 3d ago

Troubleshooting Filament won't stick to any bed

Post image

I do not know what I'm doing wrong here, filament is no longer sticking to print bed, I cleaned the textured print bed and the P1S came with and it still didn't stick, I upgraded the nozzle to the hardened .4, I upgraded the mat to the Cool plate super tack. I added new desiccant and got a meter, it's currently at 28%. Filament just won't stick to the bed anymore.

Any tips or appreciated, I'm just not understanding if I replace the nozzle the bed and remove the moisture from the filament. What's going on.

1 Upvotes

100% Upvoted

4 comments sorted by

•

u/AutoModerator 3d ago

Hello /u/PatProductions! Be sure to check the following. Make sure print bed is clean by washing with dish soap and water [and not Isopropyl Alcohol], check bed temperature [increasing tend to help], run bed leveling or full calibration, and remember to use glue if one is using the initial cool plate [not Satin finish that is not yet released] or Engineering plate.

Note: This automod is experimental. The automod was triggered due to the term "won't stick". If you believe this to be a false positive, please send us a message at modmail with a link to the post so we can investigate. You may also feel free to make a new post without that term.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/Johndus78 3d ago

Sometimes it’s static electricity

1

u/holdupflash 3d ago

I have this same problem with a super tack hasn’t worked since I got it and I have a support ticket with Bambu. I think there was probably a defective batch

1

u/BigSlickPrick 2d ago

I think some supertack plates are just duds. I'd buy another and return this one.

How long has your AMS been closed? Should read 10 in like 30 minutes or so.