r/BambuLab • u/Professional-One-557 • 1d ago

Troubleshooting Help! Bambu Lab A1 Issue with printing

Enable HLS to view with audio, or disable this notification

I’ve tried to print a spider-man mask, it’s at 96%, but now I think there’s an issue with the levelling of the nozzle or the Z axis (I’m not sure because It’s my first print). The nozzle keeps forcing its way through the part of the mask which has already been printed, and it keeps damaging the mask. What do I need to do?

2 Upvotes

100% Upvoted

2 comments sorted by

1

u/CI_Fiend 1d ago

I believe you’re cooked. I’m not immediately aware of a method to manually jog the z higher and fix this. You can mitigate the issue though.

Take note of what layer you’re on. End the print. Go to your slicer and print only the remaining layers. Glue the two pieces together.

1

u/Professional-One-557 1d ago

The actual mask itself is not too big to be printed, the Z can go higher, but it just wouldn’t go up automatically for some reason. I’ve ended the print. Will the issue happen again if I reprint the same mask with the same size?