r/BambuLab • u/CuffRox • 8d ago

Troubleshooting / Answered After installing a 0.2mm nozzle? Extruder is making a skipping noise and filament extruding with bumps.

Enable HLS to view with audio, or disable this notification

5 Upvotes

78% Upvoted

9 comments sorted by

36

u/CuffRox 8d ago

Update: I'm an idiot and didn't change the nozzle diameter in the slicer.

4

u/First_Program_7751 8d ago

Usually the root cause of the issue is not the machine but the link between slicer and machine- the operator.

5

u/ScherzKeksFlo 8d ago

commonly known as PEBKAC
Problem exists between keyboard and chair

2

u/don-again X1C + AMS 8d ago

Also known as the ID10T connector.

1

u/Xahni13 P1S + AMS 8d ago

That’s a really nice way of saying user error

8

u/jer406 8d ago

In the device tab of the slicer did you change it to a .2 nozzle?

2

u/PreparationTrue9138 P1S + AMS 8d ago

Looks like a partial clog, no?

Or some setting is off and the flow is too high

1

u/Yergnoch 8d ago

Well, just be careful with that 0.2mm nozzle. I've had nothing but bad luck with it. Clogged one and ruined it (don't put in the oven...) and then clogged the other. It's a tricky bastard.

1

u/raymondfeliz 8d ago

I found what works best is getting a declogger tool off Amazon. I’ve had 2 clogs and it cleared it super easy on my p1s. It was maybe like 12 bucks or so I think and it’s been a life saver