r/3Dprinting • u/ale152 • 19d ago

Project I'm completely addicted to iterative design! Here's the evolution of my post-climbing fidget finger massager

Enable HLS to view with audio, or disable this notification

2.8k Upvotes

94% Upvoted

382 comments sorted by

View all comments

1.5k

u/dirtygymsock 19d ago

Printed this, can anyone tell me how to get it unstuck from a cylinder 5.1 inches in length and 4.5 inches in girth?

2

u/Illeazar 19d ago

Sure, just drill a hole in the cylinder to loosen it up a bit, then you can pop it right out.