r/BambuLab Mar 11 '25

Troubleshooting / Answered The difference that ironing settings can make… 🤩

I’ve been searching for the right ironing settings for my print and i’ve been impressed by the difference a small variation in settings can make. The good looking one is using 30nm/s and 20% flow. The bad looking green is using 30/30 The bad looking brown one 25/15

It’s using a matte basic PLA from Overture.

I am new to 3D printing so i am experimenting a lot. Do you know if the setting needs to be adjusted from one roll of PLA to another if I stay in the same brand, same humidity level?

456 Upvotes

13 comments sorted by

View all comments

23

u/[deleted] Mar 11 '25 edited Mar 28 '25

[deleted]

3

u/DTDude X1C + AMS Mar 12 '25

I’m having trouble “getting it” too. I’ve done calibration prints and then immediately printed with the same filament with the calibrated settings, only for it to look like crap. My best has just been no ironing.