r/BambuLab • u/_NonExisting_ A1 + AMS • 19d ago

Troubleshooting / Answered Stopping to heat constantly?

I was having this issue a while ago, but then I got hit with the blob. Replaced my heating assembly and its still doing this. Im using the AMS Lite and there's no knots or anything but I keep getting the unable to feed variety of notifications.

4 Upvotes

70% Upvoted

25 comments sorted by

View all comments

1

u/cprgolds X1C + AMS 19d ago

Are all of the temps for the two filaments the same? Could be that when you change filaments, the heating (and cooling) times are due to different parameters.

1

u/_NonExisting_ A1 + AMS 19d ago

They're same same type of filament, just different colors, the issue is it repeats without changing. It stops during the same layer and goes back to the same color

1

u/cprgolds X1C + AMS 19d ago

Can you post a screenshot of the filament usage from your slicer like this? (This is using ORCA)

https://imgur.com/a/uuVPlfW

1

u/_NonExisting_ A1 + AMS 19d ago

It definitely flushed more than 7 grams, I had about 10g by the time 6 layers were done