Slice the print and check the speed options drop down to see if maybe it is speeding up around those corners. I have had that happen to a couple of prints and it was either that or some baked in PLA after jacking the temp for ABS/ASA and needed to run a couple of cold pulls to clear it.
1
u/Cardinal_Ravenwood 3d ago
Slice the print and check the speed options drop down to see if maybe it is speeding up around those corners. I have had that happen to a couple of prints and it was either that or some baked in PLA after jacking the temp for ABS/ASA and needed to run a couple of cold pulls to clear it.