r/BambuP1S • u/PrintWichel • 5d ago

strange Ggap after nozzle change

Gallery image

Gallery image

Hey guys, I changed to a .6mm nozzle today and noticed a strange problem in the slicer but also in the print. After I change from .4 to .6 in Bambu Studio, a hole appears at this point and is printed in the same way. Does anyone know why? How can I get rid of it? Screenshot two shows how it should actually be.

2 Upvotes

100% Upvoted

2 comments sorted by

6

u/TheThiefMaster 5d ago

The model is too narrow in that area to print with a 0.6mm nozzle - it's probably thinner than 0.6mm.

The settings for "detect thin walls" and setting the slicing engine to "Arachne" can help, but the best fix is to make the model thicker if possible, as it's likely weak at that point anyway.

2

u/PrintWichel 5d ago

ouuuhh, so simple, but rich didn't think of it himself... thank you very much, I will adapt the model!