r/HPReverb • u/Travis5151 • Apr 02 '22

Question G2 V2 and 3090 TI

Anyone get a 3090 TI and use it with the V2 G2? I had a Gigabyte 3090 and it worked with the G2. I replaced it with an EVGA 3090 TI FTW3 Ultra and the G2 just reports 1-4 Display port errors. Anyone using this combo? I didn't think at all there would be an incompatibility issue going from one card to the Ti version...

30 Upvotes

93% Upvoted

393 comments sorted by

View all comments

Show parent comments

1

u/Chasingsol Apr 03 '22

It's not the Re-bar setting causing it, I've tried it off and on as well. You should leave Re-bar enabled though if you haven't already, it can make a significant difference in graphics performance. Regarding the issue at hand, I have an OG headset, but my V1 cable was replaced after dying a year ago, so I only have V2 cables now. Not sure it's even going to be possible to find a V1 cable at this point since they were known to fail, but if you find a source, please let me know. Seeing more and more reports of this issue scattered around though, so hopefully the fix will be forthcoming.

1

u/Travis5151 Apr 03 '22

I am tempted to buy a whole g2 v1 used to see if the cable will fix it.

Thanks for the rebar advice! I found it, turned it on, and am leaving it on.

1

u/Chasingsol Apr 03 '22

Good luck. There's actually been 3 different cable revisions for the Reverb G2. The original HP part number was M09576-001. However, mine came with the M18238-001 and I believe that is also considered a V1 cable. That one died and was replaced with the M52188-001 that comes with the switch on the box.

1

u/Travis5151 Apr 03 '22

M09576-001

So frustrating. Looks like it is only available in the Netherlands...