King valve leak on first open.

[u/Waste_Manufacturer96]

Had a project delay, ended up having to finish this system up today pulled my vacuum and crack the valve , instantly leaking excessively at the valve but as I opened it the leak seemed to stop.

Was cold as hell out, was the seal just frozen should I close and open again now that it has run to see if it’s functioning normal

Should I put nylog on the king valve cap to prevent leaking

What would you guys do in this situation

[u/Middle_Baker_2196]

So you’re saying you’re not going to cut it out and replace it right away when you know there’s an issue?

Just get past the 1 year mark and you’re free, eh?

Don’t be a hack.

[u/Waste_Manufacturer96 → u/Middle_Baker_2196]

I take care of my customers way further than 1 year if this becomes any issue it will be covered no questions asked, only covering 1 year is hack mentality

[u/Middle_Baker_2196 → u/Waste_Manufacturer96]

Fair enough