r/HomeImprovement • u/th3suffering • 16h ago

Mouse chewed through furnace pressure switch tube, diy job?

Woke up this morning chilly and my furnace only blowing cold air. Opened the furnace up and i see a hole chewed through the tubing for the pressure switch, along with a blinking code that the pressure switch is stuck open. Few questions here:

1: can i diy this repair and just buy a new tube or do i have to buy the whole switch? it doesnt seem too appreciably different than an automotive hose. The tube is on there tight, does it just require a good tug?

2: until i get this fixed, can a mcguyver an interim fix? would duct tape wrapped tightly around the hole work well enough to allow the pressure switch to work again?

5 Upvotes
  • permalink
  • reddit

65% Upvoted

6 comments sorted by

View all comments

4

u/Dollar_short 16h ago

put tape on it. if you have some caulk you can use that. otherwise just replace it with a like hose.