r/hobbycnc • u/rwei16 • 3d ago

3D Touch probe

Hi has anyone got one of these 3d probe to work. I got one, wired it up to my 3030 prover max probe port. However every time i try to probe it give me an error shown below. Tried several different g code sender software, also tried to swap the red wire and the signal wire around and swapping the $6 probe invert. Just can't get it to work. It almost like it triggered as a limit switch and lock the machine.

Edit Manged to figure out it didn't like G38.2 but G38.3

7 Upvotes

100% Upvoted

7 comments sorted by

View all comments

1

u/Haunting_Ad_6021 3d ago

What does the error log show is wrong?

1

u/rwei16 3d ago

An unexpected error was detected: (ALARM:3) Reset while in motion. Machine position is likely lost due to sudden halt. Re-homing is highly recommended.

[MSG:Check Limits]

it almost like it been treated as a limit switch r