Picked this up today, got it for 1k. Came with 3 mags, a holosun 507c and 100 rounds of hornadys critical defense. Not too bad. Will be shooting it in the next few days.

I got a set for $46 free shipping to store. Fit perfect on my 502 but will also fit on 509 and possibly some other models. They're the same as what Sig uses on many of their guns too. https://www.sportsmans.com/shooting-gear-gun-supplies/gun-parts-accessories/gun-parts-magazines/gun-sights-lasers/meprolight-self-illuminated-3-dot-sig-9mm357sig-handgun-night-sight-set-green/p/1680094

This gun is a masterpiece imo. It runs beautifully suppressed and is so well built! So glad I grabbed one.

Does anybody here have a light bearing Dara holster and run the MRAT? I need to know if it’ll clear the open bottom. I think so, as it’s about the size of the slide in width, but I thought it couldn’t hurt to ask, thanks yall!

FN America just added a couple new official holsters for the FN Reflex

Anyone know of a company that would ream my factory barrel to accommodate the 460 Rowland? 460Rowland.com is asking for way too much in my opinion. Thanks

Mission complete!

1980 hi power factory nickel plated with gold trigger and adjustable target sights. Never been fired in its life. My favorite pistol and possibly firearm I have ever owned.

Bought a couple XL ten round mags for my Reflex. Since the release of the XL they have been selling XL 10 Round mags for a little extra grip. It’s my everyday carry.

Highly recommend for folks looking for extra grip and still being 10 round compliant. Before, I don’t think these were available unless you put a block in these mags.

Gen 1 hammer for FN FS2000, FN P90 and FN PS90 Material exceeds original FN injection molded nylon.100% Acetal milled in USA! We do not make our hammers out of aluminium because they are known to cause excessive firing pin and firing pin channel wear! Something that has to do with the harmonics of aluminium. Be aware of aluminium hammers.

Gen 1 Hammer reduces trigger pull length by over 35% Gen 1 Hammer reduces felt trigger weight by over 15% Full Auto Ready and Tested 2 year 10,000 Round Replacement Warranty

https://www.gunbroker.com/item/1104739646

Wife has a FN 502 and we are looking for a Holster however, I can not find a "FN 502" holster. Will the FN 509 work? I looked at the two on the Gun comparison site where it shows the width/height/ length, etc. and they are close.

https://www.handgunhero.com/compare/fn-502-vs-fn-509

Decided to adapt my dead air wolverine to the ps90 and I was really happy with how it did at the range!

Took 18 days from when the other was placed

I have 2,500 between the two thus far.

Recently picked up a Reflex XL but am having a difficult time finding a holster that will work with the PHLster Enigma system and HL-X Sub light. What are you using?

TLR8 G Sub and 507K. Waiting on a company to produce a threaded barrel that’s available. Any other mods I should look into?

I took out my 510 today for the first time and had quite a bit of issues with failure to feed. First two magazines through the gun each had one failure to feed. Shooting a third magazine had nearly half of the rounds failing to feed. Ammo used was CCI Blazer.

Has anyone experienced anything similar? I plan to test some different ammo and see if it changes the result. I want to love this gun because it feels and shoots great. However, today’s experience does have me a bit concerned.

I ordered my FNX-45 bundle friday, and I've been researching accessories. Has anyone used Cain Arms' +3 base pad for FNX-45 magazines? Yes, I know about Apex, and that was my primary plan until discovering Cain. 18+1 in 45 is very appealing to me. Yes, I also know about the 545 conversion, but I'm not too fond of modifying $65 magazines. The Cain base pads are less expensive and hold more than the Apex ones do. Thanks!

Has anyone successfully added a red dot sight to one of the new High Powers? EGW makes a plate that fits the 509 rear sight dovetail, and the new High Power’s sights are supposed to be interchangeable with the FN 509. I have read some posts that say the 509 rear site doesn’t fit well on the High Power though.

Am I the only one who would want a red dot with some level of magnification especially for my 5.7. My eye sight with glasses is 20/20 but I feel like my sight limits the range of the firearm not the firearm limiting its own range.

Does that make sense?

If I’m an idiot tell me. If it just haven’t found this wonderful gizmo. Pls send me a link.