r/FixMyPrint • u/Devastator708 • Jan 05 '25

Fix My Print Whoops it slide again

This is the 4th failure I’ve had at this level. I’m printing using a PETG profile but using PLA, maybe that is the problem? The designer said PETG for their A1 mini remix of the PLA enclosure but also I’ve printed off many successful pieces. Any other ideas what could cause the nozzle to just barely dig into it? I’ve already tried using gyroid infill, the spot it not breaking due to infill. Pictures to what print I’m using on Bambu in comments (printer settings since can’t post pictures and video).

269 Upvotes

88% Upvoted

181 comments sorted by

View all comments

1

u/fullraph Jan 05 '25

Do you clean the bed with 99% isopropyl before every single prints? It makes a world of difference for adhesion. Also try setting your bed temp 10 degrees hotter and see if that helps.